HEIDENHAIN iTNC 530 (34049x-08) - Manual (Page 18)

Chang
e
d functions in v
e
rsion 34049x
-06
18
Changed functions in version
34049x-06
 The new HR 520 and HR 550 FS handwheels are supported (see
"Traversing with electronic handwheels" on page 557)
 New software option 3-D ToolComp: 3-D tool radius compensation
depending on the tool’s contact angle on blocks with surface normal
vectors (LN blocks, see "3-D tool radius compensation depending on
the tool’s contact angle (3D-ToolComp software option)", page 523)
 3-D line graphics is now also possible in full-screen mode (see "3-D
line graphics (FCL2 function)" on page 160)
 A file selection dialog for selecting files in different NC functions and
in the table view of the pallet table is available now (see "Calling any
program as a subprogram" on page 295)
 DCM: Saving and restoring of fixture situations
 DCM: The form for test program generation now also contains icons
and tooltips (see "Checking the position of the measured fixture" on
page 411)
 DCM, FixtureWizard: Touch points and probing sequence are shown
more clearly now
 DCM, FixtureWizard: Designations, touch points and measuring
points can be shown or hidden as desired (see "Operating
FixtureWizard" on page 408)
 DCM, FixtureWizard: Chucking equipment and insertion points can
now also be selected by mouse click
 DCM: A library with standard chucking equipment is available now
(see "Fixture templates" on page 407)
 DCM: Tool carrier management (see "Tool carrier management
(DCM software option)" on page 416)