HEIDENHAIN iTNC 530 (34049x-08) - Manual (Page 22)

New functions in v
e
rsion 34049x
-07
22
 Improvements to the DXF converter:
 Contours can now also be extracted from .H files (see "Data
transfer from plain-language programs" on page 288)
 Preselected contours can now also be selected in the tree
structure (see "Selecting and saving a contour" on page 278)
 A snap function facilitates contour selection
 Extended status display (see "Basic settings" on page 274)
 Adjustable background color (see "Basic settings" on page 274)
 Display can be changed between 2-D and 3-D (see "Basic settings"
on page 274)
 Improvements to the global program settings (GS):
 All the form data can now be set and reset under program control
(see "Technical prerequisites" on page 421)
 Handwheel superimposition value VT can be reset when tool is
changed (see "Virtual axis VT" on page 429)
 If the Swapping Axes function is active, it is now permitted to
position to machine-based positions on the axes that have not
been swapped
 Using the new SEL PGM function you can assign variable program
names via QS string parameters call them with CALL SELECTED (see
"Defining a program call" on page 454)
 Improvements to the tool table TOOL.T:
 Using the FIND ACTIVE TOOL NAMES soft key you can check
whether identical tool names are defined in the tool table (see
"Editing tool tables" page 187 ff)
 The input range of the delta values DL, DR and DR2 have been
increased to 999.9999 mm (see "Tool table: Standard tool data"
page 180 ff)
 The following additional functions are now available in the expanded
tool management (see "Tool management (software option)" on
page 203):
 Importing of tool data in CSV format (see "Importing tool data" on
page 208)
 Exporting of tool data in CSV format (see "Exporting tool data" on
page 210)
 Marking and deleting of selectable tool data (see "Deleting marked
tool data" on page 210)
 Inserting of tool indices (see "Operating the tool management" on
page 205)