beautypg.com

6 ether n et int e rf ace – HEIDENHAIN iTNC 530 (34049x-08) User Manual

Page 663

background image

HEIDENHAIN iTNC 530

663

1

7.6 Ether

n

et int

e

rf

ace

Network settings specific to the device

Press the DEFINE MOUNT soft key to enter the network settings
for a specific device. You can define any number of network
settings, but you can manage only seven at one time

Setting

Meaning

MOUNTDEVICE

Connection via NFS:
Name of the directory that is to be logged
on. This is formed by the network address
of the server, a colon and the name of the
directory to be mounted. Input: Four
numerical values separated by periods,
ask your network specialist for the proper
value, e.g. 160.1.13.4:/PGM directory of
the NFS server that you wish to connect
to the TNC. Be sure to differentiate
between small and capital letters when
entering the path

Connection via smb:
Enter the network name and share name
of the computer, e.g. \\PC1791NT\C

MOUNTPOINT

Name that the TNC shows in the file
manager for a connected device.
Remember that the name must end with a
colon. Maximum length = 8 characters; the
special characters _ - $ % & # are permitted

FILESYSTEMTYPE

File system type.
NFS:

Network File System

SMB:

Server Message Block (Windows

protocol)

OPTIONS for
FILESYSTEMTYPE
=nfs

Data without spaces, separated by commas,
and written in sequence. Switch between
upper and lower case letters.
RSIZE=

: Packet size in bytes for data

reception. Input range: 512 to 8192
WSIZE=

: Packet size in bytes for data

transmission. Input range: 512 to 8192
TIME0=

: Time in tenths of a second, after

which the TNC repeats a Remote Procedure
Call not answered by the server. Input
range: 0 to 100 000. If there is no entry, the
standard value 7 is used. Use higher values
only if the TNC must communicate with the
server through several routers. Ask your
network specialist for the proper value.
SOFT=

: Definition of whether the TNC should

repeat the Remote Procedure Call until the
NFS server answers.
"soft" entered: Do not repeat the Remote
Procedure Call
"soft" not entered: Always repeat the
Remote Procedure Call