HEIDENHAIN iTNC 530 (34049x-08) - Manual (Page 577)

HEIDENHAIN iTNC 530 577
14.5 Using t
o
uc
h-pr
obes
14.5 Using touch-probes
Overview
The following touch probe cycles are available in the Manual Operation
mode:
Please note that HEIDENHAIN grants a warranty for the
function of the touch probe cycles only if HEIDENHAIN
touch probes are used!
Function Soft key Page
Calibrating the effective length Page 582
Calibrating the effective radius Page 583
Measuring a basic rotation using a line Page 587
Setting the datum in any axis Page 591
Setting a corner as datum Page 592
Setting a circle center as datum Page 593
Setting a center line as datum Page 594
Measuring a basic rotation using two
holes/cylindrical studs Page 595
Setting the datum using four
holes/cylindrical studs Page 595
Setting a circle center using three
holes/cylindrical studs Page 595