HEIDENHAIN iTNC 530 (34049x-08) - Manual (Page 29)

Chang
e
d functions in v
e
rsion 34049x
-04
HEIDENHAIN iTNC 530 29
Changed functions in version
34049x-04
 DCM: Retraction after collision simplified (see "Collision monitoring
in the manual operating modes", page 402)
 The input range for polar angles was increased (see "Circular path CP
around pole CC" on page 246)
 The value range for Q-parameter assignment was increased (see
"Programming notes", page 310)
 The pocket-, stud- and slot-milling cycles 210 to 214 were removed
from the standard soft-key row (CYCL DEF >
POCKETS/STUDS/SLOTS). For reasons of compatibility, the cycles
will still be available, and can be selected via the GOTO key
 The soft-key rows in the Test Run operating mode were modified to
those of the smarT.NC operating mode
 Windows XP is now used on the dual-processor version (see
"Introduction" on page 720)
 Conversion from FK to H was moved to the special functions
(SPEC FCT)
 Filtering of contours was moved to the special functions (SPEC FCT)
 Loading of values from the calculator was changed (see
"Transferring the calculated value into the program" on page 157)