HEIDENHAIN iTNC 530 (340 49x-05) Pilot - Manual (Page 59)

59
Definin
g
Machining Operations
Unit 240 Centering
Parameters on the overview form:
 T : Tool number or name (switchable via soft key)
 S : Spindle speed [rpm] or cutting speed [m/min or ipm]
 F: Centering feed rate [mm/min] or FU [mm/rev]
 Select Depth/Diameter: Select whether centering is based on the
depth or diameter.
 Diameter: Centering diameter. Input of T-ANGLE from TOOL.T
required.
 Depth: Centering depth.
 Machining positions (see “Defining Machining Positions” on page
145.)
Additional parameters on the tool detail form:
 DL : Delta length for tool T
 M function : Any miscellaneous function M
 Spindle : Direction of spindle rotation. As a default, smarT.NC sets M3
 Tool preselect : If needed, this is the number of the next tool for faster
tool change (machine-dependent)
Additional parameters on the drilling parameters detail form:
 None