HEIDENHAIN iTNC 530 (340 49x-05) Pilot - Manual (Page 108)

108
Definin
g
Machining Operations
Unit 123 Contour Pocket Floor Finishing
With the floor finishing unit you can finish the floor of a contour pocket
that has been roughed-out with unit 122.
Parameters on the overview form:
 T : Tool number or name (switchable via soft key)
 S : Spindle speed [rpm] or cutting speed [m/min or ipm]
 F: Feed rate for plunging [mm/min], FU [mm/rev] or FZ [mm/tooth]
 F : Feed rate for plunging [mm/min] or FU [mm/rev] or FZ [mm/tooth]
Additional parameters on the tool detail form:
 DL : Delta length for tool T
 DR : Delta radius for tool T
 DR2 : Delta radius 2 (corner radius) for tool T
 M function : Any miscellaneous function M
 Spindle : Direction of spindle rotation. As a default, smarT.NC sets M3
 Tool preselect : If needed, this is the number of the next tool for faster
tool change (machine-dependent)
Globally effective parameters on the global data detail form:
 Retraction feed rate
Always run the floor finishing operation before side finishing!