HEIDENHAIN iTNC 530 (340 49x-05) Pilot - Manual (Page 208)

208
Gra
phica
lly Testing and
Runnin
g a Unit Program
Running a unit program
You can run a unit program in the Execute submode in the following
ways:
„ Run the unit program unit by unit
„ Run the entire unit program
„ Run individual, active units
You can run UNIT programs (*.HU) in the smarT.NC
operating mode, or in the usual Program Run, Single Block or
Program Run, Full Sequence operating modes.
When the smarT.NC-Run operating mode is selected, the
TNC automatically deactivates all global program-run settings
that you have activated in the conventional Single Block or
Full Sequence program run modes. Refer to the
Conversational User’s Manual for more information about
this.
Please note the instructions on running a program in the
machine manual and the user’s manual.