HEIDENHAIN iTNC 530 (340 49x-05) Cycle programming - Manual (Page 41)

HEIDENHAIN iTNC 530 41
1
.2 A
v
ailable Cy
cle Gr
oups
1.2 Available Cycle Groups
Overview of canned cycles
U The soft-key row shows the available groups of
cycles.
U If required, switch to machine-specific canned cycles.
These canned cycles can be integrated by your
machine tool builder.
Cycle group Soft key Page
Cycles for pecking, reaming, boring, and counterboring Page 68
Cycles for tapping, thread cutting and thread milling Page 102
Cycles for milling pockets, studs and slots Page 136
Cycles for producing point patterns, such as circular or linear hole patterns Page 168
SL (Subcontour List) cycles which allow the contour-parallel machining of relatively complex
contours consisting of several overlapping subcontours, cylinder surface interpolation Page 180
Cycles for multipass milling of flat or twisted surfaces Page 242
Coordinate transformation cycles which enable datum shift, rotation, mirror image, enlarging and
reducing for various contours Page 260
Special cycles such as dwell time, program call, oriented spindle stop and tolerance Page 290