HEIDENHAIN iTNC 530 (340 49x-05) Cycle programming - Manual (Page 102)

102 Canned Cycles: Tapping / Thread Milling
4.1 F
undamentals
4.1 Fundamentals
Overview
The TNC offers 8 cycles for all types of threading operations:
Cycle Soft key Page
206 TAPPING NEW
With a floating tap holder, with automatic
pre-positioning, 2nd setup clearance Page 103
207 RIGID TAPPING NEW
Without a floating tap holder, with
automatic pre-positioning, 2nd setup
clearance Page 105
209 TAPPING W/ CHIP BREAKING
Without a floating tap holder, with
automatic pre-positioning, 2nd setup
clearance, chip breaking Page 108
262 THREAD MILLING
Cycle for milling a thread in pre-drilled
material Page 113
263 THREAD MILLING/CNTSNKG
Cycle for milling a thread in pre-drilled
material and machining a countersunk
chamfer Page 116
264 THREAD DRILLING/MILLING
Cycle for drilling into the solid material
with subsequent milling of the thread
with a tool Page 120
265 HEL.THREAD DRILLING/MILLING
Cycle for milling the thread into the solid
material Page 124
267 OUTSIDE THREAD MLLNG
Cycle for milling an external thread and
machining a countersunk chamfer Page 124