HEIDENHAIN ND 522 - Manual (Page 57)

ND 522/523 57
I -
3
Milling
Specific
Oper
ations
Example: Press the Arc Milling hard key to open the Entry Form:
Plane: XY (3 choices are available- XY, YZ, & XZ) Select appropriate
plane.
Center Point: Enter data, or press Note soft key
1st step: Enter data
Press PLANE soft key to select the milling plane.
Press DOWN ARROW hard key.
Enter the coordinates of the center point, or press
NOTE to set the coordinate to current position.
Press DOWN ARROW hard key
Press DOWN ARROW hard key
Enter the XY coordinates of the axis start point, or
press NOTE to set the coordinate to current position.
Enter the coordinates of the axis end point, or press
NOTE.
Press DOWN ARROW hard key
Press DOWN ARROW hard key
Enter the step size. The Step size is optional. If the
value is zero, the operator decides at run-time how far
to move between each pass.
press Enter to run the program, or the END soft key
to exit.
CENTER POINT
NEXT DATA ENTRY
START, AND END POINT
NEXT DATA ENTRY
STEP SIZE