HEIDENHAIN ND 522 - Manual (Page 44)

44 I Operating Instructions
I - 3 Milling Specific Oper
ations
Enter nominal position value for hole 2 : X = 30 mm,
mark the input as an incremental dimension, press I
soft key.
Press Enter.
Press the Y axis key.
Enter nominal position value for hole 2 : Y = 30 mm,
mark the input as an incremental dimension, press I
soft key.
Press Enter.
Traverse the X, and Y axes until the display value is
zero. The square in the graphic positioning aid is now
centered between the two triangular marks.
Press the Z axis key.
Press Enter (uses last entered preset).
Drill hole 2 : Traverse Z axis until the display value is
zero. The square in the graphic positioning aid is now
centered between the two triangular marks. Retract
the drill.
NOMINAL POSITION VALUE
NOMINAL POSITION VALUE
NOMINAL POSITION VALUE