HEIDENHAIN ND 522 - Manual (Page 54)

54 I Operating Instructions
I - 3 Milling Specific Oper
ations
Example: Press the Incline Milling hard key to open the Form:
Plane: XY (3 choices are available- XY, YZ, & XZ) Select appropriate
plane.
Start Point: Enter data, or press Note soft key
1st step: Enter data
Press PLANE soft key to select the milling plane.
Press DOWN ARROW hard key.
Enter the coordinates of the first axis start point, or
press note to set the coordinate to current position.
Press DOWN ARROW hard key
Enter the coordinates of the second axis start point,
or press note to set the coordinate to current position
Press DOWN ARROW hard key
Enter the coordinates of the first axis end point, or
press note to set the coordinate to current position.
Press DOWN ARROW hard key
Enter the coordinates of the second axis end point, or
press note to set the coordinate to current position
Press DOWN ARROW hard key
Enter the step size. The Step size is optional. If the
value is zero, the operator decides at run-time how far
to move between each pass.
press Enter to run the program, or the end soft key to
exit.
START POINT
NEXT DATA ENTRY
END POINT
NEXT DATA ENTRY
STEP SIZE