HEIDENHAIN ND 522 - Manual (Page 33)

ND 522/523 33
I -
3
Milling
Specific
Oper
ations
Tool Table Usage
Example: Setting a workpiece datum without using the probing
function.
Tool diameter 2.00
Tool length: 20.000
Tool unit: mm
Tool type: flat end mill
Press the TOOL hard key.
The cursor will default to the TOOL TABLE form.
Cursor to the tool to be defined, or enter the tool
number. Press Enter.
Enter the tool diameter (2.0mm).
Cursor down to the LENGTH field using the DOWN
ARROW key.
Enter the tool length (20.0mm) .
Cursor down to the UNITS field using the DOWN
ARROW key.
It is also possible to have the ND 522/523 determine the
length of an offset. See alternative example below.
TOOL TABLE
TOOL DIAMETER
TOOL LENGTH