HEIDENHAIN TNC 122 User Manual - Manual (Page 26)

4 Positioning with MDI
26 TNC 122
Entering and moving to positions
Select the Y axis. Y
0
Y R 0
5
Move the tool to the entered position. I
Select the X axis. X
0
X R 0
6
X blinks:
Enter the nominal position for corner point : Y = +60 mm,
Select tool radius compensation: R + and
confirm your entry.
Y blinks:
Enter the nominal position for corner point : Y = +50 mm,
Select tool radius compensation: R + and
confirm your entry.
R + / – ENT
R + / – ENT
Move the tool to the entered position. I
4
3