Polaris 2009 Victory Victory Vision - Manual (Page 115)

112
OPERATION
Oper
at
io
n
Starting The Engine
Starter Interlock
A starter interlock system prevents the motorcycle from being started in gear unless the
clutch lever is pulled in (clutch disengaged).
Tilt Sensor
A tilt sensor stops the engine if the motorcycle tips beyond 45 degrees to one side. The
check engine light will also illuminate. To restart the engine, cycle the ignition switch to the
OFF position, wait 10 seconds, then restart the engine.
NOTE:
If the motorcycle ran out of fuel completely, prime the fuel system before attempting to start
the engine. See “Priming the Fuel System” on page 111 .
1. Perform the Pre-Ride Checks beginning on page 85.
2. Mount the motorcycle and bring it to an upright position. Insert the ignition key into the
ignition switch and turn it to the ON position.
3. Set the Stop / Run switch to the RUN position. You should then hear the fuel pump run
momentarily (about 3 seconds) as it pressurizes the fuel system. When the ignition key
is turned off, a clicking sound from the IAC valve is normal.
(Continued on next page)
visionownersmanual.book Page 112 Wednesday, February 13, 2008 4:31 PM