Grass Valley LUMO Series - Manual (Page 51)

43
LUMO
User Manual
Factory Reset
The FIO-911 card can be reset to factory-
specified settings of all on-board parame-
ters by clicking the Load Factory button.
Alarm Configuration
The FIO-911 card detects and signals alarm conditions.
A status LED is positioned beside each fiber connection to the SFP module on the front panel of
the card. These four LEDs report the status of their associated channel. The significance of the
LED’s appearance for each card type is given above, in the section devoted to that card.
The iControl Alarm Configuration panel opens in a new window when the Alarm Config button
is clicked, and can be resized if needed. It allows the alarm reporting of the LUMO-CPU-ETH to
be configured. The panel is organized in columns.
Status/Name
This contains an expandable tree listing all the alarms reported by this FIO-911 card.
Each alarm name includes an icon that shows its current status:
Green: OK
Red: Alarm set
Black: Alarm not applicable (in this case, e.g. there is no SFP for inputs A and B, so all alarms
associated with them appear black.
The Card LED, Overall alarm and GSM contribution columns contain pulldown lists that allow
the level of contribution of each individual alarm to the alarm named in the column heading to
be set. Click on the alarm status in either of these columns to show the status options that are
available, then click on one to select it. If no options appear, the alarm is not user-configurable