Grass Valley LUMO Series User Manual
Page 28
20
LUMO-CPU-ETH Controller Card
Control Interfaces
4 Select Setup > Ethernet in the menu on the left to open the ethernet setup page.
5 On the SETUP | Ethernet page, enter the required information. Consult your IT department if
necessary.
Hostname: The hostname is the unique name by which this LUMO is known on the net-
work. The hostname should be 15 characters or less. The hostname may contain only the
ASCII letters 'a' through 'z' (case-insensitive), the digits '0' through '9', and the hyphen
DHCP: (Disabled for this controller)
IP address:
Enter an address appropriate for the local network
Network Mask:
Enter a mask value appropriate for the local network
Gateway:
Enter a gateway address appropriate for the local network
6 Click the Apply button to save your changes
7 Disconnect the stand-alone computer from the LUMO.
The LUMO frame is now ready to be installed in its operating location and connected to the local
network.
Once it is installed, the LUMO web page can be accessed via the network at any time using a
browser and the IP address set in the controller using the above procedure.