Icontrol interface – Grass Valley LUMO Series User Manual
Page 49
41
LUMO
User Manual
iControl Interface
When installed in a LUMO frame equipped with a LUMO-CPU-ETH controller card and
connected to a network (see Chapter 4), the FIO-911 cards may be remotely monitored and
controlled using Miranda’s iControl system.
To use iControl with the FIO-911 cards, proceed as follows:
1 Install and configure your LUMO-CPU-ETH controller for network access to enable the iCon-
trol interface. See
on page 18 for details.
2 In iControl Navigator (shown below) or iControl Websites, double-click on the icon of an
FIO-911 card to open its control panel.
•
For convenience, enter a descriptive Label in the Info panel of the card, to make it easy to
locate this specific card amongst those in the list. See
Identification and Information
page 46 for instructions.
The iControl panel for the FIO-911 card displays a series of buttons down the left-hand side.
Clicking a button changes the contents of the main window to display.
The FIO-911 series of cards share the same basic control panel layout, but the detailed informa-
tion within the main display window changes with the card’s functionality.