Using the icontrol interface – Grass Valley LUMO Series User Manual
Page 30
22
LUMO-CPU-ETH Controller Card
Control Interfaces
Using the iControl interface
The LUMO-CPU-ETH controller supports remote operation through its two rear-panel 10/100
Base-T ethernet ports, using Miranda’s iControl or a third-party solution. This manual describes
the control panels associated with the LUMO-CPU-ETH and their use.
Note - you must configure the LUMO-CPU-ETH controller with an appropriate IP address before
it can be accessed on your network by iControl. See
on page 18 for details.
Please consult the iControl User’s Guide for information about setting up and operating
iControl.
In iControl Navigator or iControl Websites,
double-click on the icon of the controller to
open its control panel.
•
LUMO-CPU-ETH controllers are identified
as LUMO Controller in the Type column of
the iControl Navigator window.
•
For convenience, enter a descriptive Label
in the Info panel of the card, to make it
easy to locate this specific frame controller
amongst those in the list. See
on page 24 for instructions.
.
The iControl panel for the LUMO-CPU-ETH
controller displays a series of buttons down
the left-hand side. Clicking a button changes
the contents of the main window to display
status reports and controls related to the topic
named on the button.
A full description of the use of the iControl
interface to configure the LUMO-CPU-ETH
card is given below, beginning on page 23.