Grass Valley LUMO Series - Manual (Page 16)

8
LUMO Housing Frame
Installation
Installing Cards in the LUMO Frame
Each card includes an integrated front panel incorporating the fiber optic connectors.
All cards can be installed with the frame power on. The card has a connector which plugs into a
backplane for distribution of power, connection to the controller card, and connections to the
input and output connectors.
To install the card:
1 To remove an existing card from the slot, unscrew the existing card front panel and gently
pull the handle on the front of the card to pull the card straight out of the slot. To add a card
in an empty position, first remove the blank card front by unscrewing it and pulling the han-
dle straight out of the slot.
2 Slide the new card into the slot and push gently on the handle to seat the connectors.
Secure the card in place with the provided front panel captive screw.
Slip the lexan that was shipped with the card over the connectors ( four BNC or eight DIN) on the
rear panel that are associated with the slot into which the card was installed. The lexan identifies
the function of the connectors for that card.
Note: Detailed information about the rear panel connections is included in the chapters describing
each card type.
Installing the Power Cord Retaining Clips
Each power supply is provided with a power cord retaining clip that holds the power cord in
place to prevent inadvertent disconnections.
With the power cord removed, install the clip into the plate that extends out beneath the power
cord socket on the rear of the frame, by slipping the two ends of the clip into a pair of holes in
the plate, and rotating the clip down into a horizontal position. Several pairs of holes are
provided to accommodate different sizes of plugs. Use the holes that position the clip closest to
the body of the plug.
Once the clip is in place, insert the power cord into the socket, and press the cord into the grip-
ping loop of the clip.