Grass Valley LUMO Series - Manual (Page 15)

7
LUMO
User Manual
B Installing the Fiber Support
If you are installing this support onto a LUMO frame which has rack mounting brackets installed,
you must remove those brackets first, and then re-install them after the fiber support has been
installed, as described in Section C.
Position the fiber support against the LUMO frame as shown in the figure , and attach it to the
frame with the eight provided screws.
C Installing the Rack Mounting Brackets with the Fiber Support
After the fiber support is installed, you may install the rack mounting brackets in either of two
positions, using four provided screws for each bracket. The figure illustrates the two possible
mounting positions.
Once installation of the rack mount brackets is complete, the LUMO frame should be installed
directly into a standard 19” rack using 4 standard rack-mounting screws through the four holes
in the corners of the rack mount brackets.