Grass Valley LUMO Series - Manual (Page 3)

This equipment complies with:
The power cord supplied with this equipment meets the appropriate national
standards for the country of destination.
An appropriately listed/certified mains power supply cord must be used
for the connection of the equipment to the mains voltage at either 120V~
or 240V~.
This equipment is meant to be installed in a restricted access location.
These servicing instructions are for use by qualified personnel only.
This equipment incorporates modules containing Class 1 lasers
These modules are certified by the manufacturer to comply with:
iii
LUMO
User Manual
Safety Compliance
• CSA/UL/IEC/EN 60950-1, 2nd Ed. + AM1, Information Technology Equip-
ment - Safety requirements
WARNING:
CAUTION:
To reduce the risk of electric shock, do not perform any servicing other than that
contained in the operating instructions unless you are qualified to do so. Refer
all servicing to qualified service personnel. Servicing should be done in a static-
free environment.
CAUTION: THIS UNIT HAS MORE THAN ONE POWER SUPPLY CORD. DISCONNECT
TWO (2) POWER SUPPLY CORDS BEFORE SERVICING TO AVOID ELECTRIC SHOCK.
• EN 60950-1:2006+A11
• EN 60825-1:2007
• EN 60825-2:2004+A1