Grass Valley LUMO Series - Manual (Page 39)

31
LUMO
User Manual
Time Management.
The LUMO-CPU-ETH controller is time-aware, and its internal clock can be updated manually or
via NTP.
Click the Time button
Time (UTC)
The data boxes in this section display
the time and date currently held in the
card.
Enter new values in these boxes to
change the current setting. If an auto-
matic update via NTP is not enabled,
the clock will continue to run using an
on-board reference, but precision is not
guaranteed.
Note - there is no backup battery for the
time circuit, so the time must be reset
any time the card is powered down.
NTP IP address
Click the Enable NTP box to use an NTP (Network Time Protocol) source. Enter up to three IP
addresses of NTP servers. TheLUMO-CPU-ETH card will use the first source of valid time it finds in
this list.
Alarms
The LUMO-CPU-ETH controller generates alarms for the frame in which it is installed when error
conditions are detected. These alarms are used to set the card-front Status LED and the status
icon in the top left of the iControl window.
The alarms are reported to the iControl network.
Click the Alarm Config button