Epson A794-D100 - Manual (Page 60)

Chapter 6: Programming Information A794 Owner’s Guide
March 1999 54
Write to Non-Volatile Memory (NVRAM)
Writes two-byte word, n1 n2, to location k in history EEROM.
ASCII ESC s n1 n2 k
Hexadecimal 1B 73 n1 n2 k
Decimal 27 115 n1 n2 k
Value of n1 1 st Byte
Value of n2 2 nd Byte
Range of k 0-63 (Decimal)
Select Cut Mode and Cut Paper
Selects a mode for cutting paper and cuts the paper. There are two formats for this
command, one requiring one parameter m, the other requiring two parameters m and n.
The format is indicated by the parameter m.
ASCII GS V m GS V m n
Hexadecimal 1D 56 m 1D 56 m n
Decimal 29 86 m 29 86 m n
Value of m Selects the mode as shown in the table
Value of n Determines cutting position
m Feed and Cut Mode
0, 48 Full cut (no extra feed).
1, 49 Partial cut (no extra feed).
65 Feeds paper to cutting position + (n times vertical
motion unit), and cuts the paper completely.
66 Feeds paper to cutting position + (n times vertical
motion unit), and cuts the paper partially.
Range of m 0, 48; 1, 49
65, 66 (when used with n)
Range of n 0 – 255
Default of m, n 0
Formulas
n times the vertical motion unit equals the cutting position to which the paper is fed.