Grass Valley Kameleon HD Multi-Function Modules v.3.2.0 - Manual (Page 19)

KAM-HD-MULTI—Instruction Manual 19
Configuration and Adjustments
Configuration and Adjustments
Kameleon HD configuration and monitoring can be performed using a web
browser GUI interface or a networked Newton Control Panel. This section
provides an overview of each of these controls along with the configuration
parameters available with each type of control device. It also provides an
overview of the audio configurations available on this module.
Audio Overview
There are a number of audio paths through the KAM-HD-MULTI module
that can be utilized depending on the type of audio application required.
This section gives an overview of the overall audio system and describes
the best uses of each of the audio paths and how to use the audio preset
configurations.
Audio Input Sources
Embedded audio in the SD or HD video input stream is automatically
demultiplexed and copied at the input of the module. Any or all of the eight
demuxed audio streams can be selected to be input streams to the audio
timing circuitry or bypass timing and processing completely, depending on
the type of audio and the application, and be sent directly to the AES out-
puts. The embedded audio can also be passed to the video output of the
module unmodified. Audio capabilities for different audio types are sum-
marized in
Table 2 on page 20 .
Up to eight external AES audio inputs can be connected to the rear module,
depending on the audio configuration set on the I/O Config web page (
I/O
Config Web Page on page 43 ).
Eight audio sources, can be selected from the list of demuxed inputs
and/or the external AES inputs to make up the audio that can be multi-
plexed into the output video stream or output to external AES outputs
depending on the I/O configuration of the rear module and other module
configuration setups.