Grass Valley Kameleon HD Multi-Function Modules v.3.2.0 - Manual (Page 14)

14 KAM-HD-MULTI—Instruction Manual
Installation
Cabling
All cabling to the Kameleon HD module is done on the corresponding
KAM-HD-MULTI-UR Rear (
Figure 7 on page 15 for unbalanced audio
inputs) or KAM-HD-MULTI-BR Rear ( Figure 8 on page 15 for balanced
audio inputs) at the back of the 2000 frame. There are a number of different
input and output configurations possible depending on system configura-
tion and module type.
To determine the correct cabling for your application, refer to System Config
Web Page on page 47 and the I/O Config Web Page on page 43 .
Serial or HD SDI Video Input
Connect an SD or HD SDI video input to the BNC connector, labeled VI:
• J8 on the KAM-HD-MULTI-UR Rear
• J10 on the KAM-HD-MULTI-BR Rear
Video Outputs
There are three SDI video outputs at the following BNC connectors labeled
SDO :
• J1, J6, and J7 on the KAM-HD-MULTI-UR Rear
• J1, J8, and on the J9 KAM-HD-MULTI-BR Rear
Audio Input and Outputs
The balanced and unbalanced audio connectors on the
KAM-HD-MULTI-BR and KAM-HD-MULTI-UR rear modules can be used
as input or outputs. Configuration is done on the I/O Config web page (
I/O
Config Web Page on page 43 ) or using the Audio Preset Config buttons on
the E-MEM web page ( E-MEM Web Page on page 85 ).
The KAM-HD-MULTI-UR comes with two audio breakout cables for con-
nection to the 9-pin D connectors J2 and J4. The outputs from the breakout
cables are labeled A, B, C, and D which correspond to the outputs on the
unbalanced connectors. Refer to
Figure 20 on page 44 for 8 In/0 Out,
Figure 21 on page 45 for 4 In/4 Out, and Figure 23 on page 46 for 0
In/8 Out configurations.
Data
This connection is for future use and currently not used.
Fiber IF
This connection is for future use and currently not used.