beautypg.com

Quick start procedure – Grass Valley Kameleon HD Multi-Function Modules v.3.2.0 User Manual

Page 18

background image

18

KAM-HD-MULTI—Instruction Manual

Quick Start Procedure

Quick Start Procedure

Follow the procedure below for a quick start method configuration for the
Kameleon HD module:

1.

Go to the E-MEM web page (

page 85

) to select a preset audio

configuration if your audio needs match one of the four preset modes
explained in

Audio Preset Configurations on page 23

, or set the audio

configuration on the I/O Config web page (

I/O Config Web Page on

page 43

)

2.

Go to the I/O Config web page (

page 43

) to name inputs and outputs.

3.

Go to the System Config web page (

page 47

) to configure the input

video type (HD or SD), the video input rate, and the output timing
source. Split Screen controls are also available on this page as well as on
the HD Video Proc, SD Video Proc, and Color Correction web pages.

4.

If not already connected, connect all input and output signals and
verify component and signal presence and condition on the Status web
page (

page 38

).

5.

Go to the Functional View web

page (

page 50

) to use the block diagram

links to configure each function in turn. Video processing must be
enabled on the System Config web page or with the Newton control
panel before adjustments can be made.

Note

Next, Functional View, and Back links are provided to help you navigate
through a logical configuration sequence.

6.

Use the Slot Config web page (

page 92

) to assign Slot Configuration

information such as slot name and asset number. Also link to the
2000NET module web pages to enable and disable Frame Health and
SNMP trap reporting.

7.

Use E-MEM memory (

page 85

) to store or recall configurations as

necessary.

Note

Always recall factory defaults after a software update.

8.

Refer to

Updating Software on page 97

for information on updating

software.

This manual is related to the following products: