Grass Valley Kameleon HD Multi-Function Modules v.3.2.0 - Manual (Page 11)

KAM-HD-MULTI—Instruction Manual 11
Installation
Installation
Installation of the Kameleon HD module is a process of:
• Placing the dual-height KAM-HD-MULTI-UR or KAM-HD-MULTI-BR
rear module in a rear frame slot (no other rear modules can be used),
• Placing the media module in the corresponding front slot, and
• Cabling and terminating signal ports.
The Kameleon HD module can be plugged in and removed from a 2000
Series frame with power on. When power is applied to the module, LED
indicators reflect the initialization process (see
Power Up on page 16 ).
Note The Kameleon HD must be installed in a 2000T1DNG or 2000T3NG frame
(2000NET and 2000GEN module installed) for access to a frame reference.
Module Placement in the 2000 Frame
There are twelve slot locations in both the front and rear of a Kameleon
3 RU frame to accommodate Kameleon HD modules. The
KAM-HD-MULTI module requires a dual height rear module, either the
KAM-HD-MULTI-UR or the KAM-HD-MULTI-BR, that uses two rear
module slots allowing up to 4 modules per 3 RU frame, 2 in a 1 RU frame.
Dual-height modules can be placed in any rear slot as long as there is room
in the frame.
To install a Kameleon HD module set in a 2000 Series frame:
1. Locate a vacant slot in the rear of the 3 RU frame ( Figure 1 ) or the
2000T1DNG frame ( Figure 2 on page 12 ).
Figure 1. 2000T3NG Frame, Rear View
Media section
rear slots 1-6
(with one 2000EMI blank)
Media section
rear slots 7-12
Network
and reference
input connections
Power, frame
configuration,
& frame health
connections
8341_12r2