Grass Valley Switcher Products - Manual (Page 82)

82 Switcher Products — Protocols Manual
Section 2 — Editor Protocol
Save and Load Status (6D and ED) Commands
The switcher will respond with a Status Response message on receipt of a
Status Request command. The status code reflects the current state of file
operations.
Effects Addresses
Valid effects addresses for the Save and Load Status command are defined
in
Table 90 . (This is new code generated for Kalypso and Zodiak systems.)
Status Message
Valid Status code for the Save and Load commands are defined in Table 91 .
(This is new code generated for Kalypso and Zodiak systems.)
Table 89. Save and Load Status Commands
Function Byte Count Effects Address Command Code Message
Status Request 02 EX 6D None
Status Response 04 EX ED Status (2bytes)
Table 90. Effects Addresses - Save and Load Status Command
Effects Address Assignment
0B All E-MEM Levels
1B Source Mem
1C RMem
1D System Config
1E Suite Prefs
1F User Prefs
Table 91. Status Codes - Save and Load
Status Message
0 Idle
1 Error
2 Loading
3 Saving