Zodiak systems – Grass Valley Switcher Products User Manual
Page 22
22
Switcher Products — Protocols Manual
Section 1 — Tally Protocol
buses of a pair are independent (video-video) outputs or are being used as
a video-key pair. Refer to
.
Zodiak Systems
Many Zodiak outputs are hard wired to ME outputs. These outputs will not
be reported in tally contribution information. The remaining outputs are
programmable as aux buses (single buses or aux bus pairs). Zodiak output
pairing is different from Kalypso. Note that aux bus numbers may not cor-
respond to aux output numbers since this assignment is configurable.
Output messages are organized to put Zodiak's effects send buses on the
same output IDs as used for Kalypso effects send buses. Zodiak aux
outputs 6-13 (Zodiak's effects send outputs) are reported as outputs 41-48
(Kalypso's effects send outputs). Zodiak's switched preview is also
reported as Output 6. (
).
Table 5. Output Contribution
b7
b6
b5
b4
b3
b2
b1
b0
Notes
Outputs Status (0xB)
Block ID
Block ID
1 – Outputs 1 - 8
2 – Outputs 9 - 16
3 – Outputs 17 - 24
4 – Outputs 25 - 32
5 – Outputs 33 - 40
a
6 – Outputs 41 - 48
b
a
Outputs 39 and 40 are not programmable and are always Black and Test, respectively.
b
Outputs 41 through 48 are the effects send outputs.
Outputs Status (0xB)
Block ID
Output 1 Source (1 – 128)
0
0
0
0
Out 7/8
Out 5/6
Out 3/4
Out 1/2
Mode
0 – Video-video
1 – Video-key
Output 2 Source (1 – 128)
Out 8
Out 7
Out 6
Out 5
Out 4
Out 3
Out 2
Out 1
On-air
Output 3 Source (1 – 128)
Output 4 Source (1 – 128)
Output 5 Source (1 – 128)
Output 6 Source (1 – 128)
Output 7 Source (1 – 128)
Output 8 Source (1 – 128)