Grass Valley Switcher Products - Manual (Page 75)

Switcher Products — Protocols Manual75
Editor Commands
Setting Bit 6 to one recalls an Effects Dissolve into an E-MEM register. This
has the same effect as pushing the EFF DIS pushbutton and then recalling
an E-MEM register from the control panel. Setting Bit 2 prevents the Effects
dissolve from taking place irrespective of whether the effect was learned
with Effects Dissolve on, or the Effects Dissolve button was pressed prior
to sending the Recall E-MEM command. If both Bits 6 and 2 are zero, then
the Effects Dissolve will occur if the effect was learned with Effects Dissolve
on, or if the Effects Dissolve button is on (has just been pressed).
Auto Recall is controlled by the bits in the same manner as Auto Run,
described above.
It is possible to combine Force bits to automatically run a register starting
with an effects dissolve after the enabled levels have been recalled.
Registers
Valid E-MEM registers are 00 through 99 (00H–63H). The format of the
Effects Register Number byte is provided in
Table 71 .
4000 Bit-Mask Format
The two-byte bit mask allows the editor to specify any combination of
effects addresses 00 through 7FF. The LSB (bit 0) represents the first
address, and bit 10 represents the DPM 4 address. The top bits are “don't
care.” This is used with the FF Effects Address.
Table 71. Effects Register Number Byte Format
Bit
7 6 5 4 3 2 1 0
0 X X X X X X X
Combination of 7 bits makes values used for
Effects Register 00H – 63H