Grass Valley Switcher Products - Manual (Page 63)

Switcher Products — Protocols Manual63
Editor Commands
Wipe Pattern (C8) Command
The Wipe Pattern command selects the specified Transition Wipe 1 or Tran-
sition Wipe 2 pattern for an M/E. Only one Transition Wipe 1 and one Tran-
sition Wipe 2 pattern can be active at a time for each M/E.
Kalypso Effects Addresses
Valid effects addresses used by Kalypso systems for the Wipe Pattern
command are defined in
Table 49 .
Zodiak Effects Addresses
Valid effects addresses used by Zodiak systems for the Wipe Pattern
command defined in
Table 50 .
Table 48. Wipe Pattern Command
Function Byte Count Effects Address Command Code Message
Wipe Pattern 03 EX C8 Wipe #
Table 49. Kalypso Effects Addresses - Wipe Pattern Command
Effects Address Assignment
00 PGM-PST
01 Mix/Effects 1
02 Mix/Effects 2
03 Mix/Effects 3
04 PGM-PST Secondary Partition a
a New effects address assignment associated with Kalypso.
05 Mix/Effects 1 Secondary Partition
a
06 Mix/Effects 2 Secondary Partition a
07 Mix/Effects 3 Secondary Partition a
Table 50. Zodiak Effects Addresses - Wipe Pattern Command
Effects Address Assignment
00 PGM-PST
01 Mix/Effects 1
02 Mix/Effects 2
03 Mix/Effects 3