Grass Valley K2 Media Client Service Manual Nov.18 2008 User Manual
Page 74
74
K2 Media Client Service Manual
July 28, 2008
Chapter 3 Service Procedures
This procedure can be used on a K2 Media Client that needs to be restored to its
factory default state. For example, if you neglected to make a first birthday image, you
might need to use this procedure. If the image from which you are restoring was made
from the specific K2 Media Client, refer to the previous procedure
system-specific recovery disk image on E:”
NOTE: This procedure restores the K2 Media Client (both C: and D: partitions) to
its factory default condition. Passwords and other site-specific configurations are
reset to factory defaults and all media is lost.
1. Make sure that media access is stopped and that the K2 Media Client on which you
are working is not being used.
2. If you have not already done so, connect keyboard, monitor, and mouse to the K2
Media Client.
3. Insert the Recovery CD and restart the machine. If there is a problem restarting,
hold the standby button down for five seconds to force a hard shutdown. Then press
the standby button again to startup.
The machine boots from the disc. The Acronis True Image program loads.
4. At the startup screen, select
True Image (Full Version)
.
The Acronis True Image program loads.
The Acronis True Image main window appears.
5. In the Acronis True Image main window, click
Recovery
.
The Restore Data Wizard opens.
6. On the Welcome page, click
Next
.
The Archive Selection page opens.
7. In the tree view expand the node for the E: partition and select the image file, then
click
Next
:
The Verify Archive Before the Restoring page opens.
8. Leave the selection at
No, I don’t want to verify
and then click
Next
.
The Partition or Disk to Restore page opens.
9. Select
System (C:)
and then click
Next
.
The Restored Partition Location page opens.
10. Select
System (C:)
and then click
Next
.
The Restored Partition Type page opens.
11. Leave the selection at
Active
and then click
Next
.
The Restored Partition Size page opens.
12. Leave settings at their defaults. The size reported in the upper pane is the size
detected of the actual C: partition. This should be the same as that reported in the
Partition size field in the middle of the page. Free space before and Free space after
should both be reported at 0 bytes. Click
Next
.
The Next Selection page opens.