Grass Valley iControl Solo v.6.00 - Manual (Page 68)

Installing IC-USB
Connecting the IC-USB Device to a Miranda Symphonie Frame
64
Connecting the IC-USB Device to a Miranda Symphonie Frame
To connect the IC-USB to a Miranda Symphonie Frame
1. Connect IC-USB, RJ-45-to-DE-9 female adapter and Ethernet cable as described under
"Connecting the IC-USB Device to a Miranda Quartet 2 Frame" , above.
2. Connect the RJ-45-to-DE-9 male adaptor to the Ethernet cable.
3. Connect the male adaptor to one of the RS-422 female DE-9 ports in the back of the
Symphonie frame:
IC-USB connected to a Miranda Symphonie frame
Determining the IC-USB COM Port Number
The IC-USB COM port number is required to configure the Miranda iControl Solo Imaging
Communicator service.
To determine the COM port number associated with IC-USB
1. On the Start menu, point to Programs, then to Inside Out Networks, and click Edgeport
Configuration Utility.
2. Expand the Edgeport 1i line item from the General Tab.
The COM port number is specified in brackets.
Installing a Single Imaging Frame
Ensure that the frame is properly terminated (refer to the Installation Guide for your Quartet 2
or Symphonie frame).
Installing Multiple Imaging Frames
A maximum of four Imaging frames (Quartet 2 and Symphonie) can be daisy-chained
together. Each individual frame in the daisy chain requires a different serial identification
assignment. The last frame in the chain must be terminated (refer to the Installation Guide for
your Quartet 2 or Symphonie frame).