Grass Valley iControl Supported Devices V.2 - Manual (Page 79)

iControl
Supported Device Reference Guide
71
Certain parameters may be passed to the plug-in, as follows:
Speed Duplex Text/Signal gbeStatusSpeedDuplex Status Of Speed Duplex
--- Output IP: Output port 1 alarms ---
System Bitrate Text/Signal gbeOut1SystemBitrate GBE port1 out System Bitrate
Valid Bitrate Text/Signal gbeOut1ValidBitrate GBE port1 Valid Bitrate
Stream source Text/Signal gbeOut1Source Stream source of GBE por1 out. Can be "asi", "dvb-
s-s2", "ds3", "gbe", "descrambled"
Dest IP Text/Signal gbeOut1DestIP Dest IP of GBE port1 out.
Dest port Text/Signal gbeOut1DestPort Destport of GBE port1 out.(0~65535)
TTL Text/Signal gbeOut1TTL TTL Of GBE out port1 out.(1~255)
alarm OnOff Statustext/Signal gbeOut1AlarmEnable Alarm OnOff of GBE port1 out. "on" or "off".
--- Output IP: Output port 2 alarms ---
System Bitrate Text/Signal gbeOut2SystemBitrate GBE port2 out System Bitrate
Valid Bitrate Text/Signal gbeOut2ValidBitrate GBE port2 Valid Bitrate
Stream source Text/Signal gbeOut2Source Stream source of GBE port2 out. Can be "asi", "dvb-
s-s2", "ds3", "gbe", "descrambled"
Dest IP Text/Signal gbeOut2DestIP Dest IP of GBE port2 out.
Dest port Text/Signal gbeOut2DestPort Destport of GBE port2 out.(0~65535)
TTL Text/Signal gbeOut2TTL TTL Of GBE out port2 out.(1~255)
alarm OnOff Statustext/Signal gbeOut2AlarmEnable Alarm OnOff of GBE port2 out. "on" or "off".
Parameter Description
alarmPath Used to set the Alarm prefix.
Default value: Sumavision
Could be replaced by IRD so as to have legacy plug-ins tree look-like.
pollInterval Poller interval in seconds. Overwrites the default interval of 20 seconds.
retries If an SNMP request times out, this defines the number of retries to be performed.
Default: 1
timeout Delay in seconds before declaring a timeout in the current SNMP request.
uniqueID An extra identifier to be assigned to the plugin to differentiate its alarms from the other
plugin of the same type. The
uniqueID should be part of URI.
readCommunity SNMP read community string. Use for SNMP polling.
Default value: public
Health monitoring alarms (Continued)
Alarm name Type MIB point Further details