Grass Valley iControl Supported Devices V.2 - Manual (Page 35)

iControl
Supported Device Reference Guide
27
Critical high temperature detected Text/Status No
Backup port activated Text/Status No
Ethernet backup port active Text/Status No
Ethernet Gbe Port fail Text/Status No
High temperature warning Text/Status Yes
Critical Software card error Text/Status Yes
Ethernet AutoNegotiation failed Text/Status Yes
Firmware download failure Text/Status Yes
Firmware upgrade failure Text/Status Yes
Voltage error Text/health Yes
Communication Status Status No Raise a critical condition if the device stops
responding to polling for a time period
defined by pollinterval X retries.
Device Restart Status No Raise a minor condition based on the value of
sysUpTime read is smaller by at least 60
seconds compared to last reading. The value
increase by 100 every second.
System uptime Text/Status No
--- MPEG alarms ---
MPEG Sync loss Text/Status No
Output overflow Text/Status No
Program Decoding failure Text/Status No
DSR sync loss Text/Status No
Continuity error on primary port Text/Status No
Input overflow Text/Status No
Program decoding Failure PCR err Text/Status Yes
Program decoding failure unsupported Text/Status Yes
Framrate mismatch Text/Status Yes
Low delay stream in normal mode Text/health Yes
AC gen lock not synched Text/Status Yes
AC Eth dejitter fail Text/Status Yes
Pid Conflict Text/health Yes
MPEG synch loss on backup port Text/Status Yes
Continuity error on backup port Text/Status Yes
(Continued)
Alarm name Type Optional? Further details