Grass Valley iControl Supported Devices V.2 - Manual (Page 56)

Supported Devices
MIBs Used
48
Certain parameters may be passed to the plug-in, as follows:
MIBs Used
The plug-in is currently compliant with the MIB MITEQ-160061 . The RFC1213 MIB point
sysUpTime is used to detect device reboot and loss of communication.
Motorola
Parameter Description
AlarmPath Used to set the Alarm prefix.
Default value: PBI
Could be replaced by IRD to have legacy plug-ins tree look-like.
pollInterval Poller interval in seconds. Overwrite the default interval of 20 seconds.
retries If an SNMP request times out, this defines the number of retries to be performed.
Default: 1
timeout Delay in seconds before declaring a timeout in the current SNMP request.
uniqueID An extra identifier to be assigned to the plug-in to differentiate its alarms from the other
plug-in of the same type. The
uniqueID should be part of the URI.
readCommunity SNMP read community string. Use for SNMP polling.
Default value: public
writeCommunity SNMP write community string. Use to set SNMP variable.
Default value: private
nbConverter Number of converter to monitor.
By default, monitor all converters (12 + 1 backup)
cvSelWaitTime Defines the number of milliseconds to wait after the converter selection.
Default: 200 ms
Ordering information
Hardware New in
iControl
version
GSM plug-in name Order number
"APEX 1000" SNMP — Motorola APEX IC-SNMP-123
"CAP-1000" 4.30 SNMP — Motorola CAP-1000 IC-SNMP-134
"CP7600 (formerly Terayon CP7600)"
"DM6400 CherryPicker (formerly Terayon DM6400)" SNMP — Motorola DM 6400 IC-SNMP-175
"DSR-4410" SNMP — Motorola DSR-4410 IC-SNMP-165
"DSR-4440" 6.02 SNMP — Motorola DSR-4440 IC-SNMP-238
"DSR-4460" 4.30 SNMP — Motorola DSR-4460 IC-SNMP-152