Grass Valley iControl Supported Devices V.2 - Manual (Page 45)

iControl
Supported Device Reference Guide
37
Isilon
Please see "EMC" , on page 18.
JDSU
MVP-200 MPEG Video Probe
VSA API v2
The VSA is an MPEG-2 Video Probe. The VSA typically supports a 4-port Napatech Gigabit card
and can run MPEG-2 analysis on each port simultaneously.
The plug-in supports three types of alarms: Health alarms , Streams alarms , and Programs
alarms , as follows:
Ordering information
Hardware New in iControl
version
GSM plug-in name Order number
"MVP-200 MPEG Video Probe" SNMP — JDSU MVP-200 IC-SNMP-162
"VSA API v2" 6.02 IC-SNMP-255
Alarm name Type Further details
--- Health monitoring alarms ---
Communication Status/health Raise a critical condition if the device does not respond to HTTP
request or does not respond with HTTP code 200.
Notification ready Status/health Set to critical condition at start. The status is cleared as soon as a
notification is received.
Board [X] Status StatusText There is an alarm for each board seen by the plugin. State can be
normal / "monitoring", or critical / "idle".
AlarmCount Text Shows the number of "statefull" alarms that are read from "nmap"
query. If lightweight_driver is set, then this alarm should show 0.
API version Text Show the VSA API version of the device
--- Streams alarms ---
Overall Status Virtual alarm for status and detailed alarms.
Status Status Overall alarm given by the VSA for the stream.
--- Programs alarms ---