Grass Valley iControl Supported Devices V.2 - Manual (Page 68)

Supported Devices
Pro Broadband, Inc. (PBI)
60
Certain parameters may be passed to the plug-in, as follows:
Multicast IP address Text/Signal multicastIPAddress ethernet output multicast IP address
TS packets per UDP Text/Signal tsPacketPerUDP ethernet output TS packets per UDP
TTL Text/Signal ttl ethernet output ttl
External board netmask Text/Signal sourceNetmask External board netmask
External board gateway Text/Signal sourceGateway External board gateway
External board mac Text/Signal sourceMac External board mac
Multicast port Text/Signal multiUDPPort Multicast port
Protocol Text/Signal protocol Protocol : udp or trp
Type service Text/Signal typeService normal, min delay, max throughput, max reliability, min
monetary cost
Source StatusText/Si
gnal source Text can be asi, tuner, ds3, CI. Status is NORMAL if
source value correspond to the parameter "inputType".
If source is unlnown or does not match, status is set to
CRITICAL .
Mode Text/Signal mode DVB , IPTV
Max Channel Text/Signal maxChannel when mode is IPTV, hardware sustain max channel
Current MaxChannel Text/Signal curMaxChannel when mode is IPTV, device can output channel number
most currently
Channel Input Text/Signal channelInput when mode is IPTV, input channel number currently
MulticastValues Text/Signal multicastValues when mode is IPTV, the value of multicast
Gateway Mac address Text/Signal gatewayMac gateway mac address
HighTargetMac Text/Signal highTargetMac when mode is IPTV, it denote all multicast channel's
target mac, only save high 32bit, one channel occupy 4
bytes
LowTargetMac Text/Signal lowTargetMac when mode is IPTV, it denote all multicast channel's
target mac, only save target mac's low 16bit, one
channel occupy 4 bytes, latter 2 bytes is effective
TargetMac4Dvb Text/Signal targetMac4Dvb when mode is DVB, the target mac address
Parameter Description
AlarmPath Used to set the Alarm prefix.
Default value: PBI
Could be replaced by IRD so as to have legacy plug-ins tree look-like.
pollInterval Poller interval in seconds. Overwrite the default interval of 20 seconds.
Health monitoring alarms (Continued)
Alarm name Type MIB point Further details