Grass Valley iControl Supported Devices V.2 - Manual (Page 55)

iControl
Supported Device Reference Guide
47
--- Health monitoring alarms ---
These alarms are created by generic.js
Device
Communication Status/health sysUpTime (RFC1213) Raise a critical condition if the device stops
responding to polling for a time period defined
by pollinterval X retries.
Device Restart Status/health sysUpTime (RFC1213) Raise a minor condition based on the value of
sysUpTime read is smaller by at least 60 seconds
compared to last reading. The value increase
by 100 every second.
--- Status alarms ---
Control Mode Text/health status Control mode
• 0 = Local control
• 1 = Remote control
Redundancy Mode Status/health status Redundancy mode
• 0 = Manual
• 1 = Automatic
Redundancy Chain
Position Text/health status Chain position in standby
• 00 = Backup converter
• 01 = Primary converter 1
• 12 = Primary converter 12
Polarization Text/health status Polarization switch position
• 0 = None
• 1 = Horizontal
• 2 = Vertical
Power Supply A Status/health status Power Supply ‘A’ Alarm
Power Supply B Status/health status Power Supply ‘B’ Alarm
Converter bus fault Status/health status Converter bus fault
Converter Contact
fault Status/health status Converter Contact fault
Switch Module fault Status/health status Switch Module fault
Switch Module Bus
fault Status/health status Switch Module Bus fault
write community Status/health writeCommunity Check the write community defined in the device
correspond to the configured one. This is
important as the plug-in performs SNMP
SET
operations.
1. The switchover can monitor up to 12 converters + 1 backup.
2. This alarm can be set to
UNKNOWN if cvalr data does not match the pattern ?abcdef.
3. This alarm can be set to UNKNOWN if converter cannot be selected with an SNMP set.
(Continued)
Alarm name Type MIB point Further details