Grass Valley iControl Supported Devices V.2 - Manual (Page 44)

Supported Devices
IRTrans
36
IRTrans
LAN Controller XL Infrared Control System
The IRTrans LAN Controller XL is an infrared LAN controller with eight IR outputs, an RS232
interface, 2 inputs for external receivers, 4 relay outputs, and a 10/100 Mb Ethernet
connection.
Device Restart Status/health Poller sysUpTime
(RFC1213)
Raise a minor condition based on the value of
sysUpTime read is smaller by at least 60 seconds
compared to last reading. The value increase by
100 every second.
System uptime text/health Poller sysUpTime
(RFC1213)
System up time alarm, this is a default health
monitoring alarm when you use the
generic.js to create a new custom driver
--- Signal alarms ---
hw_revision Text Fast poller hw_revision
sw_version Text Fast poller sw_version
serial_number Text Fast poller serial_number
fault input 1 Status Fast poller fault_input_1
fault input 2 Status Fast poller fault_input_2
power A Status Fast poller power_A_status
power B Status Fast poller power_B_status
control_source Text Fast poller control_source
fp_force_mode Text Fast poller fp_force_mode
contact closure Status Fast poller input_contact_
closure
switch mode Text Fast poller switch_mode
switch state Text Fast poller switch_state
fault output Status Fast poller fault_output
Ordering information
Hardware New in iControl
version
GSM plug-in name Order number
"LAN Controller XL Infrared
Control System" SNMP — IRTrans LAN Controller XL IC—DR—016
(Continued)
Alarm name Type Polling or
trap?
MIB point Further details