Grass Valley iControl Supported Devices V.2 - Manual (Page 69)

iControl
Supported Device Reference Guide
61
QLogic
SAN Fiber Channel Switches
The QLogic SAN Fiber Channel Switch family comprise a series of Fibre Channel (FC) protocol
switches for use as the backbone of storage area networks (SANs).
Quest Controls Inc.
TELSEC RM/WM-Series Controller
The TELSEC RM/WM-series controller is used to monitor/control environmental and access
control functions as well as equipment alarming at a remote site.
retries If an SNMP request timeout, this defines the number of retries to be performed.
Default value: 1 .
timeout Delay in seconds before declaring a timeout in the current SNMP request.
uniqueID An extra identifier to be assigned to the plug-in to differentiate its alarms from the other
plugin of the same type. The
uniqueID should be part of uri.
readCommunity SNMP read community string. Use for SNMP polling.
Default value: public
inputType Defines the signal input type.
Value can be DVB_S , ASI or IP
Default value: DVB_S
outputType Defines the signal output type.
Value can be ASI or IP
Default value: IP
Ordering information
Hardware New in
iControl
version
GSM plug-in name Order number
"SAN Fiber Channel Switches" SNMP — QLogic SAN Fiber Channel Switches IC-SNMP-202
Ordering information
Hardware New in iControl
version
GSM plug-in name Order number
"TELSEC RM/WM-Series Controller" SNMP — Quest Telsec WM IC-SNMP-149
(Continued)
Parameter Description