Grass Valley Aurora Ingest v.6.1 - Manual (Page 54)

44 Aurora Ingest System Guide May 2007
Chapter 3 Using Aurora Ingest - Scheduler
once. See “Adding Recurring Events” on page 44 for instructions.
4. Then, fill out the information needed for CompuSat setting.
• Event Name—Enter a name for the scheduled event. If you had entered Clip
Title in the General tab, the same name will appear in this box.
• Satellite—Select the satellite that you want to record the event from in the
drop-down list.
• Transponder—Select the corresponding transponder to record the event from on
the drop-down list.
• Receiver—Select the corresponding receiver to record the event from on the
drop-down list.
• Audio Frequency—Select the corresponding audio frequency that you need for
this event on the drop-down list.
• Audio Level/Video level—Set the corresponding percentage of audio and video
levels that you need for this event. If not, you can always check the default box
for default settings.
5. Click Add .
The scheduled event is added to Scheduler with a Ready status.
Adding Recurring Events
If you want to schedule an event to record on more than one occasion, such as every
day of the week, or once a week, you create a recurring event. Scheduling a recurring
event is the same as scheduling a one-time recording except that you enter
information about how the event recurs throughout time.
NOTE: If using CompuSat, you can only schedule weekly recurring events.