Grass Valley Aurora Ingest v.6.1 - Manual (Page 39)

May 2007 Aurora Ingest System Guide 29
Configuring VTR Ingest (VTR)
Configuring VTR Ingest in the VTR Ingest application: VTR tab
Make sure you have already configured the VTR Controller application before
completing this section. The VTR information in these two applications needs to
match. For more information, see
“Configuring VTR Controller” on page 26 .
1. In the VTR Ingest application, select Tools | Options .
2. In the VTR tab, enter the IP address or name of the Aurora Ingest Server.
3. If desired, check the prompt for Tape ID box. This feature allows you to customize
the identification of your tape.
4. Select the channel from the drop-down list and enter the name of the channel.
5. Enter the IP address or name of the computer where VTR Controller is installed.
(If VTR Controller is installed on the same machine, enter localhost .)
6. Select the com port from the drop-down list.
7. From the list of available VTRs, select the VTR router source. Once selected, the
router source is displayed in the Selected VTR box.
8. You can check the Enable RS-422 Switching box and select the RS-422
destination.
9. To make the changes but keep the Options dialog box open, click Apply .