H3C Technologies H3C SecPath F100-C-EI - Manual (Page 74)

Installation Manual
H3C SecPath F100-C-EI Firewall
Chapter 5 Maintaining Software
5-24
Exit and reboot, are you sure?[Y/N]y
System is rebooting now ...
3) Configure a new user password in system view after the
system reboots.
system-view
[H3C] user-interface console 0
[H3C-ui-console0] authentication-mode password
[H3C-ui-console0] set authentication password simple
123456
The above information indicates that the Console port
authentication mode is password authentication, and the password for
the console port is 123456, in plain text..
Note:
z
After the system restarts, it runs using the initial configuration, but
the previous configuration file is still stored in the storage medium.
To restore to the previous configuration, use the display
saved-configuration
command to display the previous
configuration, and then copy and execute the previous
configuration.
z
If the password is stored in plain text, you can use the display
current-configuration
command to view the password in the
current configuration. If you use the cipher keyword in the set
authentication password
command, for example, set
authentication password cipher 123456
, the password is stored
in cipher text.