H3C Technologies H3C SecPath F100-C-EI - Manual (Page 68)

Installation Manual
H3C SecPath F100-C-EI Firewall
Chapter 5 Maintaining Software
5-18
Caution:
z
When using FTP to upgrade the application program, make sure
that the firewall has enough free space on the flash memory. If the
free space is not enough, you need to use the delete /unreserved
command to permanently delete outdated files or other files;
otherwise, new files cannot be uploaded.
z
The Boot ROM upgrade is not complete after the Boot ROM
program is uploaded by using the put command. To complete the
upgrade, use the upgrade bootrom [ full ] command to
decompress the bootrom/bootromfull program from the root
directory in the flash memory and write it to the Boot ROM.
z
After uploading the application program into the flash memory,
rename the program file to “system” to make the program take
effect at next startup.
z
After uploading configuration files into the flash memory, rename
the file to “config.cfg” to make the files take effect at next startup of
the system, or use the startup saved-configuration command to
set the attribute of the file so that it will be used at the next startup.
z
Download application program files or configuration files
ftp> get Get means downloading the file.
remote file Type the name of the application
program/configuration file to be downloaded.
local file Type the name of the application
program/configuration file to be saved after it is
downloaded to the local end.