H3C Technologies H3C SecPath F100-C-EI - Manual (Page 38)

Installation Manual
H3C SecPath F100-C-EI Firewall
Chapter 3 Installing the Firewall
3-9
Figure 3-8
Connect the console cable
3.5.2 Connecting the Ethernet Cables
Follow these steps to connect the Ethernet cables:
1) Connect one end of the Ethernet cables to the fixed Ethernet
interfaces of the firewall and the other end to the peer
devices. Because 10 Mbps/100 Mbps Ethernet interfaces
support MDI/MDIX auto-sensing, you can use either a
straight-through cable or a crossover cable when connecting
such a port to a hub or LAN switch.
2) After powering on the firewall, check the status of the LINK
LEDs for the fixed Ethernet interfaces. For the LINK LED
status description, refer to Table 1-2 on page 1-5.