4 connecting the power cord, I. ac power supply, Ii. ac power source socket – H3C Technologies H3C SecPath F100-C-EI User Manual

Page 35: 4 connecting the power cord -6, Figure 3-6, Connect pgnd wire to grounding strip -6

Installation Manual
H3C SecPath F100-C-EI Firewall

Chapter 3 Installing the Firewall

3-6

(1) Hex nut

(2) PGND wire

(3) Bare metal wire

(4) Grounding post

(5) Grounding strip

Figure 3-6

Connect PGND wire to grounding strip

Note:

The resistance reading between the firewall chassis and the earth
ground must be less than 5 ohm.

3.4 Connecting the Power Cord

AC power supply

AC power input range: 100 to 240 VAC, 50/60Hz

II.

AC power source socket

You are recommended to use a three-wire single-phase
power socket with a neutral point.