H3C Technologies H3C SecPath F100-C-EI - Manual (Page 37)

Installation Manual
H3C SecPath F100-C-EI Firewall
Chapter 3 Installing the Firewall
3-8
Caution:
If the PWR LED does not light up after the above procedure is
repeated several times, refer to Chapter 6 “Troubleshooting” on page
6-1 in this manual.
3.5 Connecting Interface Cables
3.5.1 Connecting the Console Cable
Follow these steps to connect the console cable:
1) Select a console terminal.
The console terminal can be a standard ASCII terminal
possessing an RS-232 serial port, or, more often, a common PC.
2) Connect the console cable.
Disconnect the firewall from the power source. Plug the RJ-45
connector of the console cable into the console port of the firewall, and
the DB-9 (female) connector into the serial port of the console
terminal.
3) Verify the connection and power on the firewall.
The console terminal should display the startup information of the
firewall. For details, refer to Figure 3-8.